 Hunter
Gullies offer a wide range of applications to suit most building situations.
The Hunter bottle gully trap (DS46) circular top and (DS49) square
top, can be used to remove surface water from paved pedestrian areas.
Side and back boss inlets accept waste water from ground floor domestic
appliances and/or rainwater from roofs.
By adding a raising piece (DS48) the gully grating can be installed
where paving is set at varying heights, where a new surface is laid
or if deep bedding is required. It can be cut to the desired length
to allow the gully to be installed at depths of up to 600mm, reducing
the need for additional bends.
The square top is sized at 200mm with spacer nibs at the edges to
complement block paving and is designed to make finishing neat and
simple when installed in slab or block paved areas. The offset top
is designed to fit snugly against a wall, reducing the need for time-consuming
or untidy finishing. The gully top accepts a standard Hunter circular
grille which meets all the requirements for load-bearing without the
need for screws. |
|
